Application Notes / PBA Systems / Direct Drive Linear Motor Selection Guide

Product Selection

Direct Drive Linear Motor Selection Guide

PBA Systems direct drive linear motors couple the motor force straight to the payload, so there's no ball screw, belt, or gearbox in between.

Bravo Automation Technologies is an authorized distributor of PBA Systems direct drive linear motors and linear stages and serves customers in the Upper Midwest (North Dakota, South Dakota, Iowa, Missouri, Illinois, Minnesota, Indiana, Wisconsin and Michigan). Browse the PBA Systems product page.

PBA-AN-001PBA Systems EngineeringFebruary 2024

Overview

That gets you zero backlash, no mechanical wear, very high acceleration, and positioning down to the nanometer. Picking the right motor comes down to matching force, speed, and thermal behavior to what the application actually needs.

Force and Speed Requirements

The two numbers that drive the choice are continuous force and peak force at your target speed. A linear motor gives you full force at any speed up to the thermal limit, which a rotary-to-linear conversion can't do:

  • Continuous force: Limited by thermal dissipation of the forcer coil
  • Peak force: Available for short durations (typically 3-5× continuous)
  • Speed: Determined by back-EMF voltage vs. available bus voltage
  • Acceleration: F = m × a (total moving mass × desired acceleration)
  • Calculate RMS force for the complete motion profile

Ironless vs Ironcore Motors

PBA makes both ironless (U-channel) and ironcore (flat) motors. Ironless has no cogging and no attractive force between forcer and magnets, which is what you want for precision work. Ironcore packs more force per unit area but brings cogging and magnetic pull with it. Go ironless for nanometer positioning, ironcore when you need raw force on an industrial machine.

Force density comparison: Ironcore ≈ 20-50 N/cm² continuous, Ironless ≈ 5-15 N/cm² continuous. Ironless cogging: <0.5% of peak force. Ironcore cogging: 2-8% of peak force (reducible with skewing).

Thermal Management

Continuous force is capped by heat, not by the magnets. The coil dumps heat (P = I²R) that has to go somewhere. If you need more continuous force, a liquid-cooled forcer can run at 2-3× the air-cooled rating. And make sure the mounting surface actually conducts heat away from the motor.

Typical applications

  • Semiconductor lithography
  • Precision assembly automation
  • High-speed pick-and-place
  • Laser processing equipment

Related products

FLA Series • FLU Series • FLC Series. See them on the PBA Systems page or ask us for a quote.

View the original resource

Tell us what you are building

We will help you pick the right PBA Systems part and quote it.